Through Fastened Steel Roofing

But that risk disappeared when roofers switched to screws with integral neoprene washers.

Through fastened steel roofing.

In the days before cordless drills were invented through fastened metal roofing was installed with nails. Place the first screw about 7 inches from the bottom and each subsequent screw about 18 to 24 inches apart along the vertical run. Grand v panels provide an economical solution to the metal roofing needs of today. Low end metal roofing consists of panels called through fastened panels.

Select up to 3 products to compare. Exposed fastener metal roofing is defined as a roofing system where the panels are fastened to the structure through the face of the metal and directly into the roof deck or framing below. Install the roofing screws vertically along each rib in the panel. Through fastened panels are generally attached with screws or nails which puncture the overlapping roofing sections to lock the panels into place.

They are also installed using washers which provide leakage protection around the puncture hole. A generous 36 coverage category leading finishes and high production volumes combine to ensure that everyone can afford a quality steel roof system. Atas offers a wide variety of metal roofing systems from traditional shingles to batten seam panels that allow for unlimited design flexibility and creativity. Metal roofing through fastened panels.

The panel edges lap one another and the fastener goes through both layers of metal. These nails would tend to back out and result in leakage. Grand c panels provide an economical solution for today s metal roofing needs. Through fastened exposed roofing panels.

Through fastened roof systems are cost effective long lasting and beautiful. These high quality metal roof panels are fastened using color matched screws with neoprene rubber washers. Secure the screws but do not overtighten. These high quality metal roof panels are fastened using color matched screws with neoprene rubber washers.

The washer under the screw head should seal to the surface of the panel without bulging or shifting.